A general approach to modeling technologies of conformance control from injection side
https://doi.org/10.51890/2587-7399-2022-7-3-84-95
Abstract
Introduction. The processes of conformance profile control in injection wells and flow-diverting technologies are considered. A general approach to processes simulation is proposed, in which two principal components reacting in the reservoir.
Aim. The purpose of the research is to create a tool for prediction and assessment of the results of injection well treatments.
Materials and methods. It is proposed to consider the process within the framework of a problem with a small parameter, in which the well treatment is modeled by a one-dimensional flow for each interlayer.
Results. Analytical solutions of the problem have been obtained, which make it possible to determine the reaction constant from laboratory tests and predict the redistribution of the flow near the well. These solutions can be used in a commercial software or proxy model as well-reservoir coupling coefficients. The technologies of reagents injection with subsequent displacement them into the reservoir with water injection and shut down the well for reaction after injection are analyzed.
Conclusions. The combination of the analytical analysis of the conformance improvement with simulation of waterflood by commercial software increases the scientific basis and effectiveness of the decisions of oil reservoir water management.
About the Authors
K. M. Fedorov
Tyumen State University
Russian Federation
Russian Federation
Konstantin M. Fedorov — Dr. Sci. (Phys.-Math.), Professor, Scientific advisor of the Institute of Physics and Technology
Scopus ID: 7006284104
6, Volodarskogo str., 625003, Tyumen, Tyumen area
I. V. Vydysh
Tyumen Petroleum Research Center LLC
Russian Federation
Russian Federation
Ivan V. Vydysh — Specialist
79/1, Osipenko str., 625002, Tyumen, Tyumen area
N. A. Morozovskiy
PJSC Rosneft Oil Company
Russian Federation
Russian Federation
Nikita A. Morozovskiy — Head specialist
26/1, Sofiyskaya naberejnaya str., 117997, Moscow
K. V. Toropov
PJSC Rosneft Oil Company
Russian Federation
Russian Federation
Konstantin V. Toropov — Head specialist
26/1 Sofiyskaya naberejnaya str., 117997, Moscow
D. A. Anuriev
Tyumen Petroleum Research Center LLC
Russian Federation
Russian Federation
Denis A. Anuriev — Head of the Expert and Analytical Department
79/1, Osipenko str., 625002, Tyumen, Tyumen area
A. N. Emelaynov
Tyumen Petroleum Research Center LLC
Russian Federation
Russian Federation
Andrey N. Emelaynov — Leading specialist
79/1, Osipenko str., 625002, Tyumen, Tyumen area
References
1. Agzamov F.A., Morozov D.V. Primenenie biopolimerov dlya vodoizolyatsii plastov [Application of biopolymers for water insulation of reservoirs]. Ufa. 2002. 8 pp.
2. Altunina L.K., Kuvshinov V.A. Fiziko-khimicheskie metody povysheniya nefteotdachi plastov [Physical and chemical methods of enhanced oil recovery]. Vestnik of Saint-Petersburg University, 2013. no 4(2), pp. 46–76.
3. Brilliant L.S., Antipov V.S., Starkova N.R., Gordeev A.O., Chernavskikh S.F., Chernyshov A.V., Negomedzyanov V.R. Spravochnik tekhnologa [Technologist’s Handbook]. Tyumen: OAO SIBINKOR, 1998. 91 pp.
4. Volkov V.P., Brilliant L.S. Geologicheskie osobennosti kollektorov sherkalinskoy svity Talinskoy ploshchadi [Geological features of the reservoirs of the Sherkala Formation of the Talin Area]. Petroleum. 2013. pp. 18–22.
5. Gazizov A.Sh., Nizamov R.Kh. Otsenka effektivnosti tekhnologii primeneniya polimer-dispersnoy sistemy po rezul’tatam promyslovykh issledovaniy [Evaluation of the effectiveness of the technology for the use of a polymer-dispersed system based on the results of field research.] Petroleum, 1990. № 7, pp. 49–52.
6. Zemtsov Yu.V., Mazaev V.V. Sovremennoe sostoyanie fiziko-khimicheskikh metodov uvelicheniya nefteotdachi (literaturno-atentnyy obzor) [The current state of physico-chemical methods of increasing oil recovery (literary and patent review)]. Yekaterinburg: Publishing Solutions LLC. 2021. 240 pp.
7. Kan V.A., Poddubnyy Yu.A., Sidorova I.A. Gidrogeli iz rastvorov silikata natriya [Hydrogels from sodium silicate solutions]. Petroleum, 1984. № 10, pp. 44–46.
8. Kostrigin I.V., Zagurenko T.G., Khatmullin I.F. Programmnyy kompleks «RN-KIN»: istoriya sozdaniya, razvitiya i vnedreniya [RN-KIN Software Package: History of Creation, Development and Implementation]. Scientific and Technical Bulletin of Jsc “NK “Rosneft”. 2014. № 2 (35). С. 4–7.
9. Ruchkin A.A., Yagafarov A.K. Optimizatsiya primeneniya potokootklonyayushchikh tekhnologiy na Samotlorskom mestorozhdenii [Optimizing the use of flow-rejecting technologies at the Samotlor field]. Tyumen. 2004. 129 pp.
10. Safarov F.E., Gusarova E.I., Karazeev D.V., Arslanov I.R., Telin A.G., Dokichev V.A. Poluchenie gidrogeley poliakrilamida dlya ogranicheniya vodopritokov pri razrabotke neftegazovykh mestorozhdeniy [Production of hydrogels of polyacrylamide to limit water inflows during the development of oil and gas fields]. ZhPKh, 2018. Т. 91, № 5, pp. 755–759.
11. Stromberg A.G. Fizicheskaya khimiya [Physical chemistry]. M.: High school, 1999. 527 pp.
12. Uolkot D. Razrabotka i upravlenie mestorozhdeniyami pri zavodnenii [Development and management of deposits during flooding]. М.: Schlumberger. 2001. 143 pp.
13. Frolov Yu.G., Shabanova N.A., Savochkina T.V. Kinetika geleobrazovaniya i samoproizvol’nogo dispergirovaniya gelya kremnievoy kisloty [Kinetics of gelation and spontaneous dispersion of silicic acid gel]. Colloidal Journal, 1980. Т. 42, № 5, pp. 1015–1018.
14. Shel’ E.V., Kabanova P.K., Tkachenko D.R., Bazyrov I.Sh., Logvinyuk A.V. Modelirovanie initsiatsii i rasprostraneniya treshchiny gidrorazryva plasta na nagnetatel’noy skvazhine dlya ne treshchinovatykh terrigennykh porod na primere priobskogo mestorozhdeniya [Modeling of initiation and propagation of hydraulic fracturing cracks at a discharge well for non-fractured terrigenous rocks on the example of the Priobskoye field]. PRONEFT. Professional about oil, 2020. № 2 (16), pp. 36–42.
15. Al-Anazi A., Al-Kaidar Z., Wang J., Aramco S. Modeling gelation time of organically crosslinked polyacrylamide gel system for conformance control applications. Society of Petroleum Engineers, Conference paper SPE 196775, 2019. 16 pp. https://doi.org/10.2118/196775-MS
16. Bai B., Liu Y., Coste J.-P., Li L. Preformed particle gel for conformance control: Transport mechanism through porous media. SPE Reservoir Evaluation & Engineering, 2007. vol. 10, pp. 176–184. https://doi.org/10.2118/89468-PA
17. Bedrikovetsky P., Siqueira F.D., Furtado C.A. Modified particle detachment for colloidal transport in porous media”. Transport in Porous Media, 2011. no. 86, pp. 353–383. https://doi.org/10.1007/s11242-010-9626-4
18. Caili D., Qing Y., Fulin Z. In-depth profile control technologies in China — A review of the state of the art. Petroleum Science and Technology, 2010. pp. 1307–1315. https://doi.org/10.1080/10916460903419164
19. Fedorov K.M., Gilmanov A.Y., Shevelev A.P., Kobyashev A.V., Anuriev D.A. A theoretical analysis of profile conformance improvement due to suspension injection. Mathematics, 2021. no. 9, pp. 17–27. https://doi.org/10.3390/math9151727
20. Ghaddab F., Kaddour K., Tesconi M., Brancolini A., Carniani C., Galli G. Bright Water®: A tertiary method for enhanced oil recovery for a mature field. Paper presented at the SPE Production and Operations Conference and Exhibition, 2010. June 8–10, Paper Number: SPE-136140-MS. DOI: 10.2118/136140-MS
21. Hatzignatiou D., Askarinezhad R., Giske N.H., Stavland A. Laboratory testing of environmentally friendly sodium silicate systems for water management through conformance control. Conference paper SPE 173853, 2015. https://doi.org/10.2118/173853-PA
22. Khamees T.K., Flori R.E., Fakher S.M. Numerical modeling of water-soluble sodium silicate gel system for fluid diversion and flow-zone isolation in highly heterogeneous reservoirs. Paper Number: SPE-191200, M. 2018. https://doi.org/10.2118/191200-MS
23. Krumrine P.H., Boyce S.D. Profile modification and water control with silica gels. Conference paper SPE 13578. 1985. https://doi.org/10.2118/13578-MS
24. Mabkhot S., Dashbag B., Enamul M.. Hossain simulation of ionic liquid flooding for chemical enhance oil recovery using CMG STARS software. Paper presented at the SPE Kingdom of Saudi Arabia Annual Technical Symposium and Exhibition, Dammam, Saudi Arabia, 2016. April 25–28. Paper Number: SPE-182836-MS. 14 pp. https://doi.org/10.2118/182836-MS
25. Manrique E., Reyes S., Romero J., Aye N., Kiani M., North W., Thomas C., Kazempour M., Izadi M., Roostapour A., Muniz G., Cabrera F., Lantz M., Norman C. Colloidal dispersion gels (CDG): Field projects review. Paper presented at the SPE EOR Conference at Oil and Gas West Asia, 2014. March 31–April 2, Paper Number: SPE-169705-MS. https://doi.org/10.2118/169705-MS
26. Robert D.S., Laura R.-Z. Reservoir conformance improvement. Society of Petroleum Engineers, 2011. 138 pp.
27. Seright R., Liang J. A comparison of different types of blocking agents. Paper SPE 30120 presented at the 1995 SPE European Formation Damage Control Conference, The Hague, 1995. May 15–16. https://doi.org/10.2118/30120-MS
28. Tcharkhtchi A., Nony F., Khelladi S., Fitoussi J., Farzaneh S. Epoxy/amine reactive systems for composites materials and their thermomechanical properties. Advances in composites manufacturing and process design, Elsevier, 2015. pp. 269–296. https://doi.org/10.1016/B978-1-78242-307-2.00013-0
29. Tobenna O., Robert L. Simulation and economic screening of improved oil recovery methods with emphasis on injection profile control including waterflooding. Polymer flooding and a thermally activated deep diverting gel. Paper presented at the SPE Western Regional Meeting, March 21–23, 2012. Paper Number: SPE-153740-MS. https://doi.org/10.2118/153740-MS
30. Willhite G.P. Waterflooding. Society of Petroleum Engineers, USA, 1986. 326 pp.
Review
For citations:
Fedorov K.M., Vydysh I.V., Morozovskiy N.A., Toropov K.V., Anuriev D.A., Emelaynov A.N. A general approach to modeling technologies of conformance control from injection side. PROneft. Professionally about Oil. 2022;7(3):84-95. (In Russ.) https://doi.org/10.51890/2587-7399-2022-7-3-84-95
Views:
404
Email this article 